Premium Service Plan – Heating System

Maintenance Includes:

  • An Oil Heat Efficiency Test to determine what should be done to bring your heating unit to peak efficiency
  • All necessary cleaning, lubrication and adjustments to the entire heating unit including the replacement of any parts listed for the oil burner and its controls
  • Testing to ensure all safety controls are operating properly
  • A Combustion Efficiency Audit upon completion that ensures all cleaning and adjustments have been done correctly and your unit is operating at peak level.

NO CHARGE PARTS AND LABOR during regular hours, or for “no heat” or “emergency” calls after hours that require the following:

CONTROLS: FUEL SUPPLY PARTS
Cad Cell Control
Combination Control
Emergency Switch
Fuses
High-Limit Control
Primary Control
Thermostat (manual)
Aquastat (Cold Start)
Fan Relay
Service Switch		 Flare Fittings
Fuel Filter (Complete)
Fuel Pump
Fuel Pump Bleeder
Fuel Pump Seal
Fuel Pump Strainer
Oil Line (exposed)
Oil Line Fittings
Nozzle
Nozzle Assembly
Nozzle Line
Solenoid Valve 
FURNACE SYSTEMS: BURNER PARTS:
Air Cone
Blower Bearings
Blower Belt
Blower Motor (up to 3/4 hp – non variable speed)
Flue Pipe
Draft Regulator
Low-Voltage Transformer
Inspection & Cleaning CoversBOILER SYSTEM:

Circulator Coupling
Circulator Motor (Limit one per year if applicable)
Mounts
Circulator Relay (single-zone)
Power Head (Limit one per year if applicable)

 Burner Tube
Burner Coupling
Burner Fan
Burner Flange Gasket
Burner Motor
Buss Bars
Transformer Leads
Cad Cell
Cad Cell eye
Electrodes & Porcelains’
End Cone
Ignition Transformer
Ignition Wiring
Delayed Oil Valve
Pedestal Mount (when applicable) 
15% discount on any parts not covered in full.
Subject to GENERAL TERMS AND CONDITIONS

Premium Water Heater Service Plan

Your oil fired water heater will be thoroughly cleaned and inspected in accordance with specially formulated procedures used by the Company to insure maximum, trouble free efficiency. Under the optional coverage, there will be no charge for the repair or replacement of the following parts of your water heater when they become defective due to normal wear and use, plus a 15% discount on any parts not covered in full.

Aquastat (single)
Blast Tube
Burner Coupling
Burner End Cone
Cad Cell
Cad Cell Eye
Electrodes & Porcelains’
Emergency Switch
Ignition Transformer 		 Nozzle
Fuel Oil Cartridge
Nozzle Line
Nozzle Assembly
Oil Burner Fan
Oil Burner Motor
Oil Burner Pump
Primary Control
Subject to GENERAL TERMS AND CONDITIONS

Air Conditioning Maintenance Inspection

Listed below is a checklist of items that should be inspected for proper function and operation during the preventive maintenance inspection. Repair or any future service calls and all parts requiring replacement will be billed at a 15% discount off prevailing rates. Service is only available during normal working hours.

  • Check air handler filters. Clean as necessary
  • Check condenser and clean if necessary
  • Lubricate condenser fan motor
  • Check condenser fan blades for tightness
  • Tighten electrical connections at equipment
  • Check voltage at unit under load
  • Check condensate drain for blockage. Clean as necessary
  • Check blower belt for condition, tension and alignment
  • Inspect contactor points
  • Lubricate all bearings where applicable
  • Inspect evaporator coil for cleanliness
  • Inspect starting capacitor
  • Inspect running capacitor
  • Check for vibration and noise
  • Inspect Relays
  • Check running and starting amperages
  • Check voltage at unit
  • Check pressures (suction & discharge)
  • Check temperature differential
  • No attic work

Make recommendations of any needed repairs to the system.

Economy Service Plan

Economy Maintenance Service is for customers who want to have their Heating System tuned up while enjoying a 15% discount on emergency service and all parts requiring repair or replacement.

Inspection includes the following items:

  • Inspection, cleaning & adjustments of head assembly, burner fan & motor, ignition system, controls, oil pump & combustion chamber
  • Lubricate burner motor
  • Vacuum cleaning of unit, flue pipe and chimney base (where accesible, when necessary to maintain or burner efficiency)
  • Replacement of one nozzle and one oil filter cartridge
  • Perform combustion efficiency test

Tune Up Service is only available during normal business hours.

Economy Water Heater Service

Economy Maintenance System is for customers who want to have their Hot Water Heater tuned up while enjoying a 15% discount on emergency service and all parts requiring repair or replacement

Inspection includes the following items:

  • Inspection, cleaning & adjustment of head assembly, burner fan & motor, ignition system, controls, oil pump & combustion chamber
  • Lubricate burner motor
  • Vacuum cleaning of unit, flue pipe and chimney base (where accessible, when necessary to maintain or improve burner efficiency)
  • Replacement of one nozzle and one oil filter cartridge
  • Perform combustion efficiency test.

Tune Up Service is only available during normal business hours.